Digi Connect IT 4

Virtual Private Networks (VPN) IPsec
Digi Connect IT® 4 User Guide
353
l Set the number of attempts for this recovery action to perform, before moving
to the next recovery action:
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
max_attempts int
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
The default is 3.
l Set the commands to run to attempt to recovery connectivity.
(config network interface my_wan surelink actions 0)> custom_
action_commands_modem "string"
(config network interface my_wan surelink actions 0)>
l Set the time to wait before the next test is run. If set to the default value of 0s,
the test interval is used.
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
override_interval int
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
g. Repeat for each additional recovery action.
7. Optional SureLink configuration parameters:
a. Type ... to return to the root of the configuration:
(config vpn ipsec tunnel ipsec_example surelink actions 0)> ...
(config)>
b. Set the test interval between connectivity tests:
(config)> vpn ipsec tunnel ipsec_example surelink interval value
(config)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the
format number{w|d|h|m|s}.
For example, to set interval to ten minutes, enter either 10m or 600s:
(config)> vpn ipsec tunnel ipsec_example surelink interval 600s
(config)>
The default is 15m.
c. If more than one test target is configured, set the success condition:
(config)> vpn ipsec tunnel ipsec_example surelink success_condition
value
(config)>
where value is either:
n one: Only one test needs to pass for Surelink to consider an interface to be up.
n all: All tests need to pass for SureLink to consider the interface to be up.