Digi Connect IT 4

Virtual Private Networks (VPN) NEMO
Digi Connect IT® 4 User Guide
463
(config vpn nemo nemo_example)> coaddress address IP_address
(config vpn nemo nemo_example)>
The default is defaultroute.
12. Set the GREtunnel local endpoint:
a. Set the method to determine the GREtunnel local endpoint:
(config vpn nemo nemo_example)> tun_local type value
(config vpn nemo nemo_example)>
where value is one of:
n defaultroute: Uses the same network interface as the default route.
n interface
If interface is used, set the interface.
i. Use the ? to determine available interfaces:
(config vpn nemo nemo_example)> tun_local interface ?
Interface: The network interface to use to communicate with
the peer. Set this field to blank if using the default route.
Format:
defaultip
defaultlinklocal
eth1
eth2
loopback
Current value:
(config vpn nemo nemo_example)> tun_local interface
ii. Set the interface. For example:
(config vpn nemo nemo_example)> tun_local interface wan
(config vpn nemo nemo_example)>
The default is defaultroute.
13. Configure one or more local networks to use as a virtual NEMO network interface. Generally,
this will be a Local Area Network (LAN):
a. Add a local network to use as a virtual NEMO network interface:
(config vpn nemo nemo_example)> add network end lan
(config vpn nemo nemo_example)>
b. (Optional) Repeat for additional interfaces.
14. Save the configuration and apply the change:
(config)> save
Configuration saved.
>