EasyManuals Logo
Home>Digi>Network Router>Connect IT 4

Digi Connect IT 4 User Manual

Digi Connect IT 4
964 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #474 background imageLoading...
Page #474 background image
Services Configure the web administration service
Digi Connect IT® 4 User Guide
474
l A single IP address or host name.
l A network designation in CIDR notation, for example, 192.168.1.0/24.
l any: No limit to IPv4 addresses that can access the web administration service.
d. Click again to list additional IP addresses or networks.
n To limit access to specified IPv6 addresses and networks:
a. Click IPv6 Addresses.
b. For Add Address, click .
c. For Address, enter the IPv6 address or network that can access the device's web
administration service. Allowed values are:
l A single IP address or host name.
l A network designation in CIDR notation, for example, 2001:db8::/48.
l any: No limit to IPv6 addresses that can access the web administration service.
d. Click again to list additional IP addresses or networks.
n To limit access to hosts connected through a specified interface on the Connect IT 4
device:
a. Click Interfaces.
b. For Add Interface, click .
c. For Interface, select the appropriate interface from the dropdown.
d. Click again to allow access through additional interfaces.
n To limit access based on firewall zones:
a. Click Zones.
b. For Add Zone, click .
c. For Zone, select the appropriate firewall zone from the dropdown.
See Firewall configuration for information about firewall zones.
d. Click again to allow access through additional firewall zones.
6. Multicast DNS (mDNS) is enabled by default. mDNS is a protocol that resolves host names in
small networks that do not have a DNS server. To disable mDNS, or enable it if it has been
disabled, click Enable mDNS.
7. For SSL certificate, if you have your own signed SSL certificate, paste the certificate and
private key. If SSL certificate is blank, the device will use an automatically-generated, self-
signed certificate.
n The SSL certificate and private key must be in PEM format.
n The private key can use one of the following algorithms:
l RSA
l DSA
l ECDSA
l ECDH
Note Password-protected certificate keys are not supported.
Example:

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Digi Connect IT 4 and is the answer not in the manual?

Digi Connect IT 4 Specifications

General IconGeneral
BrandDigi
ModelConnect IT 4
CategoryNetwork Router
LanguageEnglish

Related product manuals