Digi Connect IT 4 User Manual

Services Configure SSHaccess
Digi Connect IT® 4 User Guide
484
d. Click  again to allow access through additional firewall zones.
6. Multicast DNS (mDNS) is enabled by default. mDNS is a protocol that resolves host names in
small networks that do not have a DNS server. To disable mDNS, or enable it if it has been
disabled, click Enable mDNS.
7. For Private key, type the private key in PEM format. If Private key is blank, the device will use
an automatically-generated key.
8. To create custom SSHconfiguration settings:
a. Click to expand Custom configuration.
b. Click Enable.
c. For Override:
n If Override is enabled, entries in Configuration file will be used in place of the
standard SSHconfiguration.
n If Override is not enabled, entries in Configuration file will be added to the
standard SSHconfiguration.
d. For Configuration file, type configuration settings in the form of an OpenSSH sshd_config
file.
For example, to enable the diffie-helman-group-sha-14 key exchange algorithm:
i. Click Enable to enable SSHcustom configuration.
ii. Leave Override disabled.
iii. For Configuration file, type the following:
KexAlgorithms +diffie-hellman-group14-sha1
9. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the
Connect IT 4 local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Configure access control:
n To limit access to specified IPv4 addresses and networks:
(config)> add service ssh acl address end value
(config)>
Where value can be:
l A single IP address or host name.
l A network designation in CIDR notation, for example, 192.168.1.0/24.
l any: No limit to IPv4 addresses that can access the SSH service.
Repeat this step to list additional IP addresses or networks.

Digi Connect IT 4 Specifications

General

Brand	Digi
Model	Connect IT 4
Category	Network Router
Language	English