Digi Connect IT 4

Services Location information
Digi Connect IT® 4 User Guide
524
l id: Reports the vehicle ID.
l ln: Long navigation: reports the latitude, longitude, and altitude, the horizontal and
vertical speed, and heading.
l pv: Position/velocity: reports the latitude, longitude, and heading.
To remove a message type:
a. Use the show command to determine the index number of the message type to be
deleted:
(config service location forward 0)> show filter_taip
0 al
1 cp
2 id
3 ln
4 pv
(config service location forward 0)>
b. Use the index number to delete the message type. For example, to delete the id
(index number 2) message type:
(config service location forward 0)> del filter_taip 2
(config service location forward 0)>
To add a message type:
a. Change to the filter_taip node:
(config service location forward 0)> filter_taip
(config service location forward 0 filter_taip)>
b. Use the add command to add the message type. For example, to add the id
message type:
(config service location forward 0 filter_taip)> add id end
(config service location forward 0 filter_taip)>
13. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
14. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.