Services System time
Digi Connect IT® 4 User Guide
557
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click System > Time
4. (Optional) For Timezone, select either UTC or select the location nearest to your current
location to set the timezone for your Connect IT 4 device. The default is UTC.
5. (Optional) Add upstream NTP servers that the device will use to synchronize its time. The
default setting is time.devicecloud.com.
n To change the default value of the NTP server:
a. Click NTP servers.
b. For Server, type a new server name.
n To add an NTPserver:
a. Click NTP servers.
b. For Add Server, click .
c. For Server, enter the hostname of the upstream NTPserver that the device will use
to synchronize its time.
d. Click to add additional NTP servers. If multiple servers are included, servers are
tried in the order listed until one succeeds.
Note This list is synchronized with the list of servers included with NTP server configuration,
and changes made to one will be reflected in the other. See Configure the device as an NTP
server for more information about NTP server configuration.
6. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the
Connect IT 4 local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. (Optional) Set the timezone for the location of your Connect IT 4 device. The default is UTC.
To Next Page
Loading...
Need help?
General
