Digi Connect IT 4

Services Configure a multicast route
Digi Connect IT® 4 User Guide
569
/network/interface/defaultlinklocal
/network/interface/eth1
/network/interface/eth2
/network/interface/loopback
Current value:
(config service multicast test)> src_interface
b. Set the interface. For example:
(config service multicast test)> src_interface /network/interface/wan
(config service multicast test)>
7. Set a destination interface that the Connect IT 4 device will send mutlicast packets to:
a. Use the ? to determine available interfaces:
(config service multicast test)> src_interface ?
Destination interface: Which interface to send the multicast packets.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/eth1
/network/interface/eth2
/network/interface/loopback
Current value:
(config service multicast test)> src_interface
b. Set the interface. For example:
(config service multicast test)> add interface end
/network/interface/wan
(config service multicast test)>
c. Repeat for each additional destination interface.
8. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.