Digi Connect IT 4

Applications Set up the Connect IT 4 to automatically run your applications
Digi Connect IT® 4 User Guide
632
4. For Add Script, click .
The script configuration window is displayed.
Custom scripts are enabled by default. To disable, toggle off Enable to toggle off.
5. (Optional) For Label, provide a label for the script.
6. For Run mode, select the mode that will be used to run the script. Available options are:
n On boot: The script will run once each time the device boots.
l If On boot is selected, select the action that will be taken when the script
completes in Exit action. Available options are:
o
None: Action taken when the script exits.
o
Restart script: Runs the script repeatedly.
o
Reboot: The device will reboot when the script completes.
n Interval: The script will start running at the specified interval, within 30 seconds after
the configuration change is saved.
l If Interval is selected, in Interval, type the interval.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take
the format number{w|d|h|m|s}.
For example, to set Interval to ten minutes, enter 10m or 600s.
l Click to enable Run single to run only a single instance of the script at a time.
If Run single is not enabled, a new instance of the script will be started at every
interval, regardless of whether the script is still running from a previous interval.
n Set time: Runs the script at a specified time of the day.
l If Set Time is selected, specify the time that the script should run in Run time,
using the format HH:MM.
n During system maintenance: The script will run during the system maintenance time
window.
7. For Commands, type the commands that will execute the script.