Digi Connect IT 4 User Manual

User authentication Example user configuration
Digi Connect IT® 4 User Guide
712
b. Add a TACACS+ user to the tac_plus.conf file:
user = admin1 {
name ="Admin1 for TX64"
pap = cleartext password1
service = system {
groupname = admin
}
}
}
In this example:
n The user's username is admin1.
n The user's password is password1.
n The authentication group on the Connect IT 4 device, admin, is identified in the
groupname parameter.
c. Save and close the tac_plus.conf file.
3. Select the device in Remote Manager and click Actions > Open Console, or log into the
Connect IT 4 local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
4. At the command line, type config to enter configuration mode:
> config
(config)>
5. Configure the authentication methods:
a. Determine the current authentication method configuration:
(config)> show auth method
0 local
(config)>
This output indicates that on this example system, only local authentication is configured.
b. Add RADIUS authentication to the beginning of the list:
(config)> add auth method 0 radius
(config)>
c. Add TACACS+ authentication second place in the list:
(config)> add auth method 1 tacacs+(config)>
d. Verify that authentication will occur in the correct order:
(config)> show auth method
0 radius
1 tacacs+

Digi Connect IT 4 Specifications

General

Brand	Digi
Model	Connect IT 4
Category	Network Router
Language	English