Digi Connect IT 4 User Manual

User authentication Example user configuration
Digi Connect IT® 4 User Guide
717
9. Enable serial access for serialgroup2:
(config auth group serialgroup2)> acl serial enable true
(config auth group serialgroup2)>
10. Limit the user's access to serial ports 2, 4, and 8:
(config auth group serialgroup2)> add acl serial ports end port2
(config auth group serialgroup2)> add acl serial ports end port4
(config auth group serialgroup2)> add acl serial ports end port8
11. Save the configuration and apply the change:
(config auth user serialuser2)> save
Configuration saved.
>
12. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
13. Configure the users on the RADIUSserver:
a. On the ubuntu machine hosting the FreeRadius server, open the
/etc/freeradius/3.0/users file:
$ sudo gedit /etc/freeradius/3.0/users
b. Add the users to the users file:
serialuser1 Cleartext-Password := "password1"
Unix-FTP-Group-Names := "serialgroup1"
serialuser2 Cleartext-Password := "password2"
Unix-FTP-Group-Names := "serialgroup2"
c. Save and close the users file.

Digi Connect IT 4 Specifications

General

Brand	Digi
Model	Connect IT 4
Category	Network Router
Language	English