Digi Connect IT 4 - Page 72

Interfaces Wide Area Networks (WANs)
Digi Connect IT® 4 User Guide
72
n WANinterfaces:
(config network interface my_wan surelink actions 0)> action value
(config network interface my_wan surelink actions 0)>
n WWAN interfaces:
(config network interface my_wan surelink actions 0)> modem_action
value
(config network interface my_wan surelink actions 0)>
where value is one of:
n update_routing_table: Increases the interface's metric to change the default
gateway.
If update_routing_table is selected, complete the following:
l Set the number of attempts for this recovery action to perform, before moving
to the next recovery action:
(config network interface my_wan surelink actions 0)> max_
attempts int
(config network interface my_wan surelink actions 0)>
The default is 3.
l Set the amount that the interface's metric should be increased. This should be
set to a number large enough to change the routing table to use another
default gateway.
(config network interface my_wan surelink actions 0)> metric_
adjustment_modem int
(config network interface my_wan surelink actions 0)>
The default is 100.
l Set the time to wait before the next test is run. If set to the default value of 0s,
the test interval is used.
(config network interface my_wan surelink actions 0)> override_
interval int
(config network interface my_wan surelink actions 0)>
n restart_interface.
If restart_interface is selected, complete the following:
l Set the number of attempts for this recovery action to perform, before moving
to the next recovery action:
(config network interface my_wan surelink actions 0)> max_
attempts int
(config network interface my_wan surelink actions 0)>
The default is 3.