Digi Connect IT 4 User Manual

Central management Configure your device for Digi Remote Manager support
Digi Connect IT® 4 User Guide
826
18. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the
Connect IT 4 local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Digi Remote Manager support is enabled by default. To disable Remote Manager support:
(config)> cloud enable false
(config)>
4. (Optional) Set the URL for the central management server.
(config)> cloud drm drm_url url
(config)>
The default varies depending on firmware versions:
n Firmware version 22.2.9.x and newer, the default is the edp12.devicecloud.com. This
server is for device-connectivity only, and uses enhanced security through certificate-
based communication. See Digi Remote Manager support for further infomation.
n Firmware prior to version 22.2.9.x, the default is the Digi Remote Manager server,
https://remotemanager.digi.com.
5. (Optional) Set the amount of time that the Connect IT 4 device should wait before
reattempting to connect to the remotecloud services after being disconnected. The minimum
value is ten seconds. The default is 30 seconds.
(config)> cloud drm retry_interval value
where value is any number of hours, minutes, or seconds, and takes the format number{h|m|s}.
For example, to set the retry interval to ten minutes, enter either 10m or 600s:
(config)> cloud drm retry_interval 600s
(config)>
6. (Optional) Set the amount of time that the Connect IT 4 device should wait between sending
keep-alive messages to the Digi Remote Manager when using a non-cellular interface. Allowed
values are from 30 seconds to two hours. The default is 60 seconds.
(config)> cloud drm keep_alive value
(config)>
where value is any number of hours, minutes, or seconds, and takes the format number{h|m|s}.
For example, to set the keep-alive interval to ten minutes, enter either 10m or 600s:

Digi Connect IT 4 Specifications

General

Brand	Digi
Model	Connect IT 4
Category	Network Router
Language	English