EasyManua.ls Logo

Digi Connect IT 4

Digi Connect IT 4
964 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Interfaces Wide Area Networks (WANs)
Digi Connect IT® 4 User Guide
85
o
hostname: The hostname or IP address of an external server.
o
Set ping_host to the hostname or IP address of the server:
(config network interface my_wan surelink tests 1)> ping_
host hostname/IP_address
(config network interface my_wan surelink tests 1)>
o
interface_gateway. If set, an initial traceroute is sent to the hostname or IP
address configured in the SureLink advanced settings, and then the first hop
in that route is used for the ping test.
o
interface_address.
o
interface_dns: The interface's DNS server.
l Set the number of bytes to send as part of the ping payload:
(config network interface my_wan ipsec tunnel ipsec_example
surelink tests 1)> ping_size int
(config network interface my_wan surelink tests 1)>
n dns: Performs a DNS query to the named DNS server.
If dns is set, set the IPv4 or IPv6 address of the DNS server:
(config network interface my_wan surelink tests 1)> dns_server IP_
address
(config network interface my_wan surelink tests 1)>
n http: Uses HTTP(s) GET requests to determine connectivity to the configured web
server.
If http is set, set the URLof the web server.
(config network interface my_wan surelink tests 1)> http url
(config network interface my_wan surelink tests 1)>
n dns_configured: Tests communication with DNS servers that are either provided
by DHCP, or statically configured for this interface.
n interface_up: Tests the current status of the interface. The test fails if the
interface is down. Failing this test infers that all other tests fail.
If interface_up is set, complete the following:
l Set the amount of time that the interface is down before the test can be
considered to have failed.
(config network interface my_wan surelink tests 1)> interface_
down_time value
(config network interface my_wan surelink tests 1)>
where value is any number of weeks, days, hours, minutes, or seconds, and
takes the format number{w|d|h|m|s}.
For example, to set interface_down_time to ten minutes, enter either 10m or
600s:

Table of Contents

Related product manuals