Digi Connect IT 4

Interfaces Wide Area Networks (WANs)
Digi Connect IT® 4 User Guide
88
6. Add recovery actions:
a. Type ... to return to the root of the configuration:
(config network interface my_wan surelink tests 1)> ...
(config)>
b. Add a recovery action:
(config)> add network interface my_wan surelink actions end
(config network interface my_wan surelink actions 0)>
c. New actions are enabled by default. To disable:
(config network interface my_wan surelink actions 0)> enable false
(config network interface my_wan surelink actions 0)>
d. Create a label for the action:
(config network interface my_wan surelink actions 0)> label string
(config network interface my_wan surelink actions 0)>
e. Set the type of recovery action to reboot_device:
(config network interface my_wan surelink actions 0)> action reboot_
device
(config network interface my_wan surelink actions 0)>
n Set the number of attempts for this recovery action to perform, before moving to
the next recovery action:
(config network interface my_wan surelink actions 0)> max_attempts
int
(config network interface my_wan surelink actions 0)>
The default is 3.
n Set the time to wait before the next test is run. If set to the default value of 0s, the
test interval is used.
(config network interface my_wan surelink actions 0)> override_
interval int
(config network interface my_wan surelink actions 0)>
7. Optional SureLink configuration parameters:
a. Type ... to return to the root of the configuration:
(config network interface my_wan surelink actions 0)> ...
(config)>
b. Set the test interval between connectivity tests:
(config)> network interface my_wan surelink interval value
(config)>