Eaton easy500, easy700

8 Appendix
8.3 Technical data
216 Operating instructions 05/10 MN05013003Z-EN www.eaton.com
8.3.4.4 EASY512-DC-…, EASY6..-DC-.E, EASY7..-DC-...
EASY512-DC-… EASY6..-DC-.E EASY7..-DC-…
Digital inputs
Number 8 12 12
Inputs usable as analog inputs I7, I8 I7, I8, I11, I12
Status display LCD (if provided)
Potential isolation
To power supply No No No
between digital inputs No No No
from the outputs
Yes Yes Yes
Rated voltage
Nominal value 24 V DC 24 V DC 24 V DC
At signal “0”
< 5 V DC (I1 to I8) < 5 V DC (R1 to R12) < 5 V DC (I1 to I12)
At signal ”1” > 8 V DC (I7, I8) > 8 V DC
(I7, I8, I11, I12)
> 15 V DC
(I1 - I6)
> 15 V DC (R1 - R12) > 15 V DC
(I1 - I6, I9, I10)
Input current on signal 1
3.3 mA at 24 V DC (I1 -
I6)
3.3 mA at 24 V DC (R1 -
R12)
3.3 mA at 24 V DC (I1 -
I6, I9, I10)
I7, I8 (easy7..-DC-.. also I11,
I12)
2.2 mA at 24 V DC 2.2 mA at 24 V DC
Delay time from 0 to 1
Debounce ON 20 ms 20 ms 20 ms
Debounce OFF
easy512.DC-.. I1 to I8
easy6..-DC-.. R1 to R12
easy7.._DC-.. I1 to I12
Normally 0.25 ms
Delay time from 1 to 0
Debounce ON 20 ms 20 ms 20 ms
Debounce OFF • Normally 0.4 ms
(I1 - I6)
• Normally 0.2 ms (I7,
I8)
Normally 0.4 ms
(R1 - R12)
• Normally 0.4 ms
(I1 - I6, I9, I10)
• Normally 0.2 ms
(I7, I8, I11, I12)
Cable length (unshielded)
100 m 100 m 100 m