ECKELMANN UA 400 - Menu 6 Configuration UA 141

Firmware V3.15
21.04.2021
310/401
•
9.6.7 Menu 6 Configuration UA 141
CONFIGURAT POS: XXXXX
1 Refriger. Point Move to menu 6-1
2 Controller Move to menu 6-2
3 Cooling Move to menu 6-3
4 Language Move to menu 6-4
5 Alarm priorities Move to menu 6-5
6 Em.Powersupply Move to menu 6-6
7 Enhanced Move to menu 6-7
Menu6-1Refriger.Point
REFR. PT. POS: XXXXX Entry Default
Refr. Pt. Name: Text only
xxxxxxxxxxxxxxx Free text entry describing refrigeration point (see
note)
Kühlstellenregler
Item ID: XXXXX Free text entry displayed in screens after ITEM
ID (see note)
UA400
Priority: XX Alarm priority in failure of refrigeration point or
when global controller priority is set (Menu 6-5)
, ,ornumbers(0..99)
1
Refr. Sys. No.: XX No. of pack controller allocated to case/cold-
room controller
, ,ornumbers(--,
1..9)
1
Refr. Sys. Type XXX Associated compressor pack. Parameter only
required when linked to a VS 3010 BS having
several zones. If a different type of pack
controller is used, set this parameter blank (---)
, ,ornumbers(---,Z1,
Z2)
—
Temp. Zones X Number of temperature zones
Single-zone operation
Two-zone operation
, , or numbers (1, 2)
2
No. Sensors XX Number of temperature sensors connected.
After entering sensor scan is performed to
redetermine the number of sensorium of sensors
The priority must be assigned between 0..2 by older versions of the store computer (<V5.0),
seechapterAlarms and Messages of UA 400.
