ECKELMANN UA 400 - Alarm Routes; Termination of Alarm; Restart

Firmware V3.15
21.04.2021
395/401
•
•
•
•
•
•
•
•
11.1.8 Alarm routes
Adetectedalarmstateistransmittedbythecontrollerbythefollowingroutes:
Atthealarmrelay(floatingchangeovercontact15/16/18)
A local BT 300 x Operator Interface connected to DISPLAY interface
Via the CAN bus interface on a system centre / store computer / operator terminal in the E*LDS-System.
11.1.9 Termination of alarm
The condition for termination of an alarm can be selected from two basic principles:
Automatic reset of all alarms after correcting the cause
Manual reset of all alarms after correcting the cause
The manual reset of the alarm / alarm state can be performed
By switching off the controller, regardless of whether the alarm is still active
On a local BT 300 x Operator Interface connected to the display port
Via the CAN bus interface using a system centre / store computer / operator terminal in the E*LDS-System.
11.1.10 Restart
During a restart old alarms are marked with a send time stamp.