ECKELMANN UA 400 - Installing Firmware Update; Update for Controller with 9-Pole DIP Switch

Firmware V3.15
21.04.2021
98/401
•
•
•
•
•
Step 2: The PC must be restarted after the installation process:
* Further information:
USB cable: see chapter Zubehör
Installationprogram&firmmware:seehttps://edp.eckelmann.de/edp/lds/_NbH4owBiFn
Tips for Rectification of driver problems
6.6.2 Installing firmware update
When installing the firmware update, a distinction is made between two device generations:
2nd generation controller (from Oct./Nov. 2018)
Characteristic: 9-pole DIP switch
1st generation controller (since 2011)
Characteristic: 8-pole DIP switch
6.6.2.1 Update for controller with 9-pole DIP switch
Controller characteristic: 9-pole DIP switch
The settings depend on the controller type!
Step 1: Set DIP switch S3 and connect controller to PC

No error message such as "USB device not found" should be displayed on the laptop or PC. *

ThestepsdescribedinthechapterVoraussetzungen für das Firmware-Update must have been
performed once for each PC in order to perform a successful firmware update.
