ECKELMANN UA 400 - Menu 3 Clock UA 111

Firmware V3.15
21.04.2021
155/401
•
•
9.1.4 Menu 3 Clock UA 111
CLOCK POS: XXXXX Entry
1 Current Time Move to menu 3-1 1
2 Defrost timer Move to menu 3-2 2
3 Toggle Setpoints Move to menu 3-3 3
Menu 3-1 Current Time
CLOCK POS: XXXXX Entry Default
Date: XX dd.mm.yy Display and enter current weekday, date dd.mm.yy
Time: hh.mm Display and enter current time hh.mm
Daylight Saving X Display and enter automatic daylight saving
change (Y/N)
, ,(Y/N)
J
Menu3-2Defrosttimer
DERF. TIMER POS: XXXXX Entry Default
Defrost timer XXX Defrost initiation via input D11/12 ( EXT) or
internal (INT)
, ,(EXT,INT)
INT
Safe Defr Time XXX m Safe defrost time for maximum allowed
duration of defrosting (used only for internal
defrosting)
0..120 60 min
Manual Defrost XXX Status (OFF/ON) for supplementary manual
defrosting *) shown only when parameter
defrost timer = INT
, ,(ON/OFF)
OFF
Def.Tim.Z2 Separate defrost timer for zone 2 Menu 3-2-a
Defr. 1 xxxxx hh:mm Defrost start time with internal defrosting;
Weekday, time; shown only when parameter
defrost timer = INT
, , (Mo-Su etc.) or
numbers (hh:mm)
Mo-Su01:00
Defr. 2 xxxxx hh:mm Defrost start time with internal defrosting;
Weekday, time; shown only when parameter
defrost timer = INT
, ,(Mo-Suetc.)or
numbers (hh:mm)
Mo-Su07:00
Defr. 3 xxxxx hh:mm Defrost start time with internal defrosting;
Weekday, time; shown only when parameter
defrost timer = INT
, ,(Mo-Suetc.)or
numbers (hh:mm)
Mo-Su13:00
Time is defined by time master (system centre / store computer / operator terminal) when CAN bus is
connected. Any entry made will then be overwritten by the defined value.
