ECKELMANN UA 400 - Disassembling from the DIN Rail

Firmware V3.15
21.04.2021
79/401
6.1.1.2 Disassembling from the DIN rail
Step 1:Pullallmatingplugswithcablefromthecasecontroller.
Step 2:Pulloutthetworetainingspringswithaflat-bladedscrewdriveruntiltheyclickintoplace.
Step 3:RemovethedevicefromtheDINrail(A)bytiltingitupwards.
Warning - hazardous electrical voltage! Danger of electric shock!Whendisassemblingthesafety
instructions and work safety instructions mustbeobserved.Allconnectorsmayonlybeconnected
and disconnected when power is off.
