137
137
● : Returns to the previous route event
(the previous change in the route)
● : Pauses the simulation.
● : Goes to the next route event (the next
change in the route)
● : Changes the speed of the simulation.
You can select from speeds of x4, x8, or
x16. Touch again to return to normal
speed.
By using the voice control system (voice input
microphone and switch), you can set the
destination by giving voice commands. This
enables you to use functions that are usually
inoperable while driving.
● Voice control navigation can be interrupted
by touching the microphone icon on the
screen. When the icon is touched, the
screen background colour changes (green
blue). To resume navigation voice
control, touch the microphone icon again.
The differences in background colours are
explained below.
• Command standby screen (green):
This is the voice control command
standby screen. When this screen is
displayed, you can speak a command to
perform navigation control. You can
also perform control by directly touching
the commands that are displayed on the
screen.
5
(Optional) You can use the following
buttons during the simulation
(although the control buttons
disappear after a few seconds, you
can touch the map to show them
again).
6
Touch to stop the simulation.
Voice Control Navigation
1
By using the voice recognition trigger
or voice recognition switch you can
use voice commands to operate the
navigation. (See page 274)
2
When using voice commands to
operate the navigation, a command list
is displayed. Voice a command after
the “beep”. From then on, you can give
voice commands that are displayed on
the command list to set the destination
in the same manner.
To Next Page
Loading...
Need help?
General
