274
274
Other Operations
Voice Control System Operations
By using the voice control system (voice input
microphone and switch), you can perform
navigation and audio operation by saying
voice commands. This enables you to use
functions that are usually inoperable while
driving.
The voice control system may not recognise
the voice command if you do not say it
correctly.
Be aware of the following points that will
assist correct recognition.
● Speak after you hear the “beep”. If you
speak before or at the same time as the
“beep”, your command will not be
recognised.
● Speak in a loud and clear voice.
● Some voices may be difficult to recognise.
● Keep the windows closed as much as
possible while speaking. Noise such as
wind or other external sounds may prevent
correct recognition. Also, if the air
conditioner fan is too loud, it may prevent
correct recognition.
● The system does not support regional
variations or alternative phrases. Be sure
to say the specified phrases.
Under the following conditions, the voice
recognition mode will be turned off:
● Within 8 seconds after guidance, talkback
or help voice finishes playing, no voice is
recognised.
(When the screen is operated, counting of
8 seconds starts again after the screen is
touched.)
● The button is pressed and held.
● The Steering button or Hard button is
pressed.
● The current screen changes to the back
eye camera screen when shifting into the
reverse gear.
● A call is received.
When voice recognition is started, the current
audio output is muted or paused.
When the voice control system is activated,
you may speak the controls displayed on the
screen, or you may touch the corresponding
button.
For the following instructions found in this
manual, we will use “000” as a placeholder for
the command text available on your actual
system. “000” is only for demonstration
purposes.
About the Voice Control
System
Using the Voice Control
System
To Next Page
Loading...
Need help?
General
