EasyManuals Logo

Eclipse AVN827GA User Manual

Eclipse AVN827GA
303 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #29 background imageLoading...
Page #29 background image
27
27
Press in the SD memory card until you
hear it “click”, let go of the card, and then
pull it straight out.
ATTENTION
This unit supports USB memory in the
following formats.
Supported class: Mass storage class
Supported USB Ver.: USB1.0/1.1/2.0
(maximum transfer speed is the same as
USB 2.0)
Maximum consumption current: Less
than 1.0 A
Supported capacities: 16 MB to 8 GB
Do not connect USB memory devices other
than those conforming to the specifications
above. There is a possibility that some USB
memory devices that do conform to
specifications will not function correctly, due
to many variables. We suggest testing your
USB device prior to departing to your
destination.
This unit does not support commercially
available USB hubs, multi card readers,
external hard disks or portable audio players
with USB connectors.
If the USB memory connection cord of this
unit is connected to a USB device via an
extension cord, it may not function correctly.
If you lose the data in the USB memory while
using it with this unit, no compensation will
be given for the lost data. It is always a good
practice to back up data, and only access a
copy for in-vehicle use.
Leaving the USB memory for a long time in a
place exposed to direct sunlight may result
in deformation or discolouration due to the
high temperature, or cause a malfunction. In
such cases, ECLIPSE will not give any
compensation. When you are not using the
USB memory, keep it in a place away from
direct sunlight. Further, when leaving the
vehicle, do not keep the USB memory
inside.
When the audio source is USB, do not
disconnect the USB memory. Doing so may
damage the data in the USB memory.
Before disconnecting the USB memory, turn
the ignition switch to the Off position or
switch the audio source to a source other
than USB, and then disconnect it.
1
Press .
2
Touch .
3
After an SD memory card is ejected,
touch or press to close
the display.
Connecting (or
Disconnecting) the USB
Memory
1
Connect (or disconnect) the USB
memory.
Full Open
Close

Table of Contents

Other manuals for Eclipse AVN827GA

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Eclipse AVN827GA and is the answer not in the manual?

Eclipse AVN827GA Specifications

General IconGeneral
BrandEclipse
ModelAVN827GA
CategoryCar Receiver
LanguageEnglish

Related product manuals