Eclipse AVN827GA - Audio Operations; Using the Radio

179
179
You can adjust the audio output when a sub-
woofer is connected.
■ Switching the phase
The sound outputted from the sub-woofer
includes the same frequency bands as the
sound from the front/rear speakers, and
cancellation can occur under some in-vehicle
conditions. Switch the phase of the sub-
woofer to prevent this phenomenon. You can
set the phase in according to the in-vehicle
conditions.
● :
Sets the output timing of the speakers and
sub-woofer to be the same.
● :
Staggers the output timing of the speakers
and sub-woofer.
● After completing the adjustment, touch
to save the adjusted settings and
return to the previous screen.
■ Setting sub-woofer level
You can adjust the sub-woofer output level.
● You can set the output at any of 13 output
levels (+6 to -6).
● After completing the adjustment, touch
to save the adjusted settings and
return to the previous screen.
Sub-Woofer Settings
1
On the Sound Settings screen, touch
in Woofer Settings.
2
Touch or in Phase
Control.
Adjust
Normal
Reverse
Normal
Reverse
1
On the Sound Settings screen, touch
in Woofer Settings.
2
Touch or in Woofer Level.
Adjust