266
266
Back Eye Camera Operations
Other Operations
You can adjust the Back Eye Camera guide
lines as needed.
● Before displaying the guide lines, make sure
to align them with your vehicle.
● When an optional back eye camera is
connected, the guide lines are set to either
the normal mode. To use a mode that has
not set guide lines, cancel the display of
guide lines.
● If the Navigation screen is displayed,
change to the Multi screen or Audio
operations screen before performing this
operation.
● If is not displayed, touch .
● If Camera switch is not displayed, touch
to change the page.
Adjusting the guide lines
● Be sure to turn the ignition switch off when
getting off the vehicle to apply markings.
● Stop the vehicle in a safe location before
adjusting the guide lines.
1
Apply two line markings with packing
tape, etc. on the ground at a distance
of approximately 20 cm (0.656 ft) from
each side of the vehicle.
2
Move the vehicle approximately 2.5 m
(8.2 ft) straight ahead, and then apply
a line marking on the ground so that it
is under the rearmost position of the
vehicle.
Approximately 20 cm (0.656 ft)
Approximately 20 cm (0.656 ft)
3
Apply markings (four positions) on the
ground at distances of 50 cm (1.64 ft)
and 2 m (6.56 ft) from each end of the
line marking that is applied as the
rearmost position of the vehicle.
4
Touch .
5
Touch .
50 cm (1.64 ft)
2 m (6.56 ft)
Info
Info
Camera
To Next Page
Loading...
Need help?
General
