89
89
Default data fields when no destination is set while driving (you can change the values in fields
by using touch & hold):
Default data fields when performing navigation (you can change the values in fields by using
touch & hold):
* Time and distance to the destination cannot be displayed when your vehicle is located in the place
other than roads and motorways. After the vehicle returns to a road or motorway, time and
distance are displayed.
Field Explanation
Shows your current speed given by the GPS receiver.
When information is available on the map, displays the speed limit for the
current road.
Displays the current time corrected using the time zone offset. Accurate time
is acquired from the GPS satellite, while time zone information is acquired
from the map. You can also make manual settings in Units and Formats.
(Only for the Menu screen, the current time is shown in the upper left corner
of the screen.)
Shows the altitude of the road currently being driven and measured by the
GPS receiver. (There may be a maximum ±50 m of differences depending
on the reception status of GPS satellites.)
Field Explanation
Shows your current speed given by the GPS receiver.
When information is available on the map, displays the speed limit for the
current road.
Displays the current time corrected using the time zone offset. Accurate time
is acquired from the GPS satellite, while time zone information is acquired
from the map. You can also make manual settings in Units and Formats.
(Only for the Menu screen, the current time is shown in the upper left corner
of the screen.)
Shows the altitude of the road currently being driven and measured by the
GPS receiver. (There may be a maximum ±50 m of differences depending
on the reception status of GPS satellites.)
*
Displays the distance on the route to the final destination.
Displays the time left until arrival at the final destination based on the
information available for the remainder of the journey. This is calculated
according to prior traffic data or traffic patterns whenever available. If a TMC
receiver is connected to the main unit and is receiving data, any traffic jams
along the route are also factored into calculations. However, the accuracy of
these calculations varies greatly.
*
Displays the estimated arrival time at the final destination based on the
information available for the remainder of the journey. This is calculated
according to prior traffic data or traffic patterns whenever available. If a TMC
receiver is connected to the main unit and is receiving data, any traffic jams
along the route are also factored into calculations. However, the accuracy of
these calculations varies greatly.
To Next Page
Loading...
