Efinix Titanium - Create or Delete a Block

Titanium Interfaces User Guide
During the design process, you can generate reports, which are available in the Efinity
®
Results tab. When you generate reports, the software also saves your design.
Use the design checker to check the interface for errors and to ensure that your settings are
valid. The Interface designer displays design issues in the message viewer window. You can
also export design issues (Design > Export Design Issues) to generate a comma separated
values (.csv) report to view the issues in a spreadsheet application. When you run the design
checker, the software automatically saves your interface.
When you are done configuring your interface, click the Export Efinity Constraints Files
button to export the interface constraints to your project. The software saves the design,
checks it for errors, generates the interface reports and the interface constraint files.
Click Exit to close the Interface Designer and return to the Efinity
®
main window.
Note: You can leave the Interface Designer open while running the Efinity
®
software. However, if you
make changes to the Efinity project, the Interface Designer is not updated until the next time you launch it.
Create or Delete a Block
Create Block Create GPIO Bus Delete Block
To create a block:
1. Select the folder for the block type you want to create.
2. Click the Create Block button.
To create a GPIO bus, click the GPIO folder and then click the Create GPIO Bus button.
To delete a block, select the block name and click the Delete Block button.
Tip: Right-clicking a folder name opens a context-sensitive menu. From there you can choose Create Block (and
Create Bus for GPIO).
www.efinixinc.com 10