Efinix Titanium - Design Check: Configuration Messages

Titanium Interfaces User Guide
Design Check: Configuration Messages
When you check your design, the Interface Designer applies design rules to your
configuration settings. The following tables show some of the error messages you may
encounter and explains how to fix them.
configuration_rule_clock (error)
Message Internal Reconfiguration Interface is enabled but clock pin name is invalid
To fix Enter a valid clock name.
seu_rule_start (error)
Message Empty SEU Start Detection pin name found
To fix Enter a valid start pin name.
seu_rule_interval (error)
Message Invalid wait interval <#> microsec
To fix Change the wait interval to one that is in range. Allowable values are 0 - 1677721.
seu_rule_error (error)
Message Empty Error Status pin name found
To fix Enter a valid error pin name.
seu_rule_param (error)
Message Invalid parameters configuration: <feature list>
To fix One of the parameters you set was incorrect. Review any other errors for details.
seu_rule_sample_device (error)
Message SEU Detection is not supported in ES device
To fix You get this error if you try to enable SEU for the Ti60ES. SEU is not supported in this FPGA.
www.efinixinc.com 20