Endress+Hauser iTEMP TMT162 - Page 65

iTEMP TMT162 Operating menu and parameter description
Endress+Hauser 65
Expert → Sensor → Sensor n
1)
→ Sensor type n →  69
Connection type n →  70
2-wire compensation n →  70
Reference junction n →  70
RJ preset value →  71
Sensor offset n →  75
Sensor n lower limit →  94
Sensor n upper limit →  94
Sensor serial number →  94
1) n = number of sensor inputs (1 and 2)
Expert → Sensor → Sensor n → Sensor trimming→ Sensor trimming →  95
Sensor trimming lower
value
→  95
Sensor trimming upper
value
→  95
Sensor trimming min span →  96
Reset trim →  96
Expert → Sensor → Sensor n
1)
→ Linearization→ Call./v. Dusen coeff. R0, A,
B, C
→  97
Polynomial coeff. R0, A, B →  97
Sensor n lower limit →  94
Sensor n upper limit →  94
1) n = number of sensor inputs (1 and 2)
Expert → Sensor → Diagnostic settings → Sensor switch set point →  76
Drift/difference mode →  75
Drift/difference alarm delay →  75
Drift/difference set point →  76
Controller →  99
Start Value →  99
Calibration countdown →  100
Expert → Output → Lower range value →  72
Meas. range end →  72
Failure mode →  77
Error current →  78
Current trimming 4 mA →  78
Current trimming 20 mA →  78
Reset trim →  78