Proline Prosonic Flow P 500 HART Technical data
Endress+Hauser 213
2. Open the product page.
3. Select Downloads.
CE mark The device meets the legal requirements of the applicable EU Directives. These are listed in
the corresponding EU Declaration of Conformity along with the standards applied.
Endress+Hauser confirms successful testing of the device by affixing to it the CE mark.
UKCA marking The device meets the legal requirements of the applicable UK regulations (Statutory
Instruments). These are listed in the UKCA Declaration of Conformity along with the
designated standards. By selecting the order option for UKCA marking, Endress+Hauser
confirms a successful evaluation and testing of the device by affixing the UKCA mark.
Contact address Endress+Hauser UK:
Endress+Hauser Ltd.
Floats Road
Manchester M23 9NF
United Kingdom
www.uk.endress.com
RCM marking The measuring system meets the EMC requirements of the "Australian Communications
and Media Authority (ACMA)".
Ex approval The devices are certified for use in hazardous areas and the relevant safety instructions are
provided in the separate "Safety Instructions" (XA) document. Reference is made to this
document on the nameplate.
Functional safety The measuring device can be used for flow monitoring systems (min., max., range) up to
SIL 2 (single-channel architecture; order code for "Additional approval", option LA) and SIL
3 (multi-channel architecture with homogeneous redundancy) and is independently
evaluated and certified in accordance with IEC 61508.
The following types of monitoring in safety equipment are possible:
Volume flow
Functional safety manual with information for the SIL device
HART certification HART interface
The measuring device is certified and registered by the FieldComm Group. The measuring
system meets all the requirements of the following specifications:
• Certified according to HART 7
• The device can also be operated with certified devices of other manufacturers
(interoperability)
Radio approval The measuring device has radio approval.
For detailed information on the radio approval, see the Special Documentation
→ 216
Additional certification Tests and certificates
• Ambient temperature –50 °C (–58 °F) (order code for "Test, certificate", option JN)
• EN10204-2.1 confirmation of compliance with the order and EN10204-2.2 test report
To Next Page
Loading...
