Function Explanation
Load Memory
Loads the saved memory. When you select a
memory and press the [
] button, the settings
applied to the current image are replaced with the
settings from the memory.
Save Memory
Registers current settings in the memory. When
you select a memory name and press the [
]
button, the settings are saved.
Erase Memory
Erases the registered memory. When you select a
memory name and press the [
] button, a
message is displayed. Select Yes, and then press the
[
] button to erase the selected memory.
Rename Memory
Changes the memory name. Select the memory
name you want to change, and then press the [
]
button. Enter the memory name using the soft
keyboard.
s "Soft keyboard operations" p.158
When you have finished, move the cursor over
Finish, and then press the [
] button.
Function Explanation
Reset Memory
Resets the name and settings of a saved memory.
To reset all memories saved in Memory, Lens
Position, and Geometry Correction, use Reset All
Memories.
s Reset - Reset All Memories p.168
a
If the mark on the left of the memory name is turned blue, it
means the memory has already been registered. When you
select a registered memory, a message is displayed asking you to
confirm that you want to overwrite the memory. If you select
Yes, the previous settings are deleted and the current settings
are registered.
Memory Function
116
To Next Page
Loading...
Need help?
General
