Correcting Distortion in the Projected Image
You can correct keystone distortion in projected images using one of the
following methods.
• H/V-Keystone
This allows you to correct distortion in the horizontal and vertical
directions independently.
s "H/V-Keystone" p.67
• Quick Corner
Correct the four corners independently.
s "Quick Corner" p.68
• Curved Surface
Correct distortion that occurs when projecting on a curved surface, and
adjust the amount of expansion and contraction.
s "Curved Surface" p.69
• Corner Wall
This allows you to correct distortion that occurs when projecting on a
surface with right angles, such as a square pillar or the corner of a room,
and adjust the amount of expansion and contraction.
s "Corner Wall" p.73
• Point Correction
Corrects slight distortion which occurs partially, or adjusts the image
position in an overlapping area when projecting from multiple projectors.
s "Point Correction" p.76
Adjusting Projected Images
66
To Next Page
Loading...
Need help?
General
