Attaching the Cable Cover
By attaching the cable cover, you can hide the connected cables giving a
nice, clean finish to the projector installation. (The illustrations are of a
projector installed on a ceiling.)
Warning
Do not tie the power cord and other connection cables together. Otherwise, it
could cause a fire.
Attaching
a
Run a commercially available cable tie through the cable holder
and tie the cables together.
b
Insert the tabs on the cable cover into the two slots on the back
of the projector.
c
Tighten the two screws on the cable cover. (You can tighten the
screws with your fingers.)
Connecting Equipment
57
To Next Page
Loading...
