a
• When you change the Screen Type, adjust the aspect ratio for the
projected image as well.
s "Changing the Aspect Ratio of the Projected Image" p.82
• The Message Broadcasting function for Epson Projector Management
does not support this function.
Adjusting the position of the image on the projected screen
You can adjust the position of the image if there are margins between the
edge of the image and the projected screen frame due to the Screen Type
setting.
Example: When the Screen Type is set to 4:3 for the WUXGA/WXGA
projector
You can move the image to the left and right.
a
Press the [Menu] button while projecting.
s
"Using the Configuration Menu" p.141
b
Select Display from Extended.
c
Select Screen Position from Screen.
d
Use the [ ], [ ], [ ], and [ ] buttons to adjust the position of
the image.
You can check the current display position by using the background
test pattern.
e
Press the [Menu] button to finish making settings.
a
The Screen Position cannot be adjusted in the following situations.
• If you are using a WUXGA projector and the Screen Type is set to
16:10
• If you are using an SXGA+ projector and the Screen Type is set to
4:3
Installing the Projector
32
To Next Page
Loading...
Need help?
General
