Problems Relating to Images
No images appear
Check Remedy
Did you press the [
] button on the remote control or control
panel?
Press the [ ] button to turn on the power.
Are the indicators switched off? The power cord is not connected correctly or power is not being supplied.
Connect the projector's power cord correctly.
Check that your electrical outlet or power source is functioning correctly.
Is A/V Mute active? Press the [A/V Mute] button to release A/V Mute.
s "Hiding the Image and Sound Temporarily (A/V Mute)" p.111
Are the Configuration menu settings correct? Reset all of the settings.
s Reset - Reset All Config p.168
Is the image to be projected completely black?
(Only when projecting computer images)
Some input images, such as screen savers, may be completely black.
Is Windows Media Center displayed in full screen?
(Only during network connection)
When Windows Media Center is displayed at full screen, you cannot project using a network connection. Reduce the
screen size.
Is an application using the Windows DirectX function displayed?
(Only during network connection)
Applications using the Windows DirectX function may not display images correctly.
Are you using any other image display equipment with the
projector?
Other image display equipment may have a different resolution. Change the EDID setting from the Signal menu.
Disconnect the cable for the image currently being projected from the projector, and then make settings. If the settings
are made while the cable is connected, the settings are not applied and the image is not displayed correctly. If the cable
was connected when you made the settings, disconnect the cable, and then make EDID settings again. Also, make sure
you restart the projector after making EDID settings.
You can return settings to their initial values using the [Default] button on the remote control.
The default value for WUXGA projectors is 1920x1200/60Hz, and the default value for SXGA+ projectors is
1400x1050/60Hz.
s Signal - Advanced - EDID p.147
Problem Solving
195