Moving images are not displayed
Check Remedy
Is the computer's image signal being output to the LCD and the
monitor?
(Only when projecting images from a laptop computer or a
computer with a built-in LCD screen)
Change the image signal from the computer to external output only. Check your computer's documentation, or contact
the computer's manufacturer.
Are the contents of the moving image you are trying to project
copyright protected?
The projector may not be able to project copyright protected moving images that are being played back on a computer.
For more details, see the user's guide supplied with the player.
Projection stops automatically
Check Remedy
Is Sleep Mode set to On?
Press the [
] button to turn on the power. If you do not want to use Sleep Mode, change the setting to Off.
s Extended - Operation - Sleep Mode p.151
"The EDID is not set." is displayed
Check Remedy
Is the EDID set correctly? Disconnect the cable for the image currently being projected from the projector, and then make EDID settings again.
Also, make sure you restart the projector after making EDID settings.
s Signal - Advanced - EDID p.147
"Not supported." is displayed
Check Remedy
Do the image signal resolution and the refresh rate correspond to the
mode?
(Only when projecting computer images)
Refer to the computer's documentation for how to change the image signal resolution and the refresh rate output from
the computer.
s "Supported Monitor Displays" p.276
Problem Solving
196
To Next Page
Loading...
Need help?
General
