This projector has the following five indicators to indicate the projector's status.
A
Power indicator
Indicates the projector's status.
B
Status indicator
Indicates the projector's status.
C
Laser indicator
Indicates the light source status.
D
Temp indicator
Indicates the internal temperature status. This is normally turned off.
E
Filter indicator
Indicates the air filter status. This is normally turned off.
The following indicator status are used during regular operation.
"Status varies" indicates that the indicators turn on, off, or flash depending on the status of the projector.
Indicator Projector's Sta-
tus
Explanation
Power
supply
Status Laser Temp Filter
Blue - On Off Off Off Off
Standby condition
Power is being supplied to the projector. In this status, you can start projecting by pressing the [
] button
on the remote control or control panel.
(Sometimes, when the power cord is unplugged, the power indicator remains lit for a short period, but this
is not a fault.)
Network monitor‐
ing status
The projector is being monitored and controlled over a network (when Standby Mode is set to
Communication On).
If the power cord is disconnected and then reconnected in this status, the power indicator flashes blue.
Blue - On
Blue -
Flashing
Status
varies
Off Off
Warm-up status This is the status immediately after turning on the projector. Warm-up takes approximately 30 seconds
after the light source turns on.
The [t] button is disabled during warm-up.
Reading the Indicators
179
To Next Page
Loading...
Need help?
General
