g
Select Remote Camera Access.
When the login screen is displayed, enter your user name and
password. (The user name is EPSONWEB and the default password
is admin.)
h
Press Shoot.
i
If the password screen is displayed, enter the password you set in
step 3 for Remote Camera Access - Password, and then press
OK.
A message is displayed on the projected image, and shooting starts.
It takes approximately six seconds to acquire the image.
a
• Adjust the exposure as necessary. If you make any
adjustments, shoot again and check the adjusted image.
• When shooting, you cannot perform any operations except for
turning off the projector.
• You cannot shoot warning or caution messages.
Setting a certificate using a Web browser
You can use an electronic certificate as the projector's security settings.
a
You can install the electronic certificate from the projector's Network
menu. However, be sure to register just once or the certificate may not
install correctly.
s "Setting Up Wireless Network Security" p.133
a
Prepare a certificate that is supported by the projector.
b
Make sure the projector is turned on.
c
Launch the Web browser on the computer or mobile device
connected to the network.
Monitoring and Controlling
228
To Next Page
Loading...
