Reset Menu
Submenu Function
Reset All Memo-
ries
Resets all names and settings saved in Memory, Lens Position,
and Geometry Correction.
s "Memory Function" p.115
Submenu Function
Light Source Cal-
ibration
You can make settings related to light source calibration. When
performing light source calibration, the difference between the
white balance and the brightness level for the light source is
corrected. We recommend running this periodically.
• Run Now: Starts light source calibration. This cannot be
started in the following cases.
- Within 20 minutes of turning on the projector
- When the surrounding temperature gets too high, and
the brightness has been automatically dimmed
• Run Periodically: When set to On, light source calibration is
performed every 100 hours of usage time. When Off has been
selected to maintain a projected image that was adjusted using
multi-projection, perform corrections with Run Now or use
the scheduling function to set Light Source Calibration.
• Schedule Settings: Displays the schedule settings screen. Set
this to perform light source calibration periodically.
• Last Run: Displays the last date and time when light source
calibration was performed.
Reset All Config
You can reset all items in the Configuration menu to their default
settings.
The following items are not reset to their defaults: Input Signal,
EDID, Memory, User's Logo, all items for Network menus,
Language, Date & Time, Panel Alignment, Color Uniformity,
Lens Calibration, Color Calibration, Projector Grouping,
Screen Matching, Color Matching, Light Source Info, and
Operation Hours.
Reset All (Factory
Default)
Resets all settings for the projector. However, items for Password
Protection are not reset. You need to enter a password to perform
a reset. The default password is set to "0000". Change this to your
own desired password.
List of Functions
168
To Next Page
Loading...
Need help?
General
