Epson EB-L1505UH - The Battery that Saves Your Clock Settings Is Running Low. Is Displayed; The Projector DID Not Turn off Correctly. an Instantaneous Voltage Drop May Have Occurred. Is Displayed; Detailed Logs and Error Message Are Not Displayed; Cannot Change the Settings Using a Web Browser

"The battery that saves your clock settings is running low." is displayed
Check Remedy
The internal power supply that saves your clock settings is
running low.
Contact your local dealer or the nearest address provided in the Epson Projector Contact List.
s Epson Projector Contact List
"The projector did not turn off correctly. An instantaneous voltage drop may have occurred." is displayed
Check Remedy
Is direct shutdown enabled or did the voltage drop due to a
sudden blackout?
Check the detailed logs in status information.
s "Reading the Status Display" p.186
Detailed logs and error message are not displayed
Check Remedy
Depending on the environment, errors and warnings may not
be displayed when turning on the projector after a sudden
voltage drop, blackout, or power cut.
Wait for at least 10 seconds after turning off the projector using the power button or pulling the plug out of
the outlet before turning the projector back on or re-inserting the plug in the outlet. When the projector turns
on, check the status information.
Cannot change the settings using a Web browser
Check Remedy
Is the network device you want to connect to turned on? When the projector's Standby Mode is in Communication On standby status, make sure that the connected
network device is turned on. Turn on the network device, and then restart the projector.
s Extended - Standby Mode p.151
Problem Solving
205