h
Select the Connection Mode setting.
• Quick lets you connect to multiple smartphones, tablets, or
computers directly using wireless communication.
• Advanced: Lets you connect to a smartphone, tablet, or computer
over a wireless LAN access point.
i
If you selected the Advanced connection mode, select Search
Access Point to select the access point you want to connect to.
a
If you need to assign the SSID manually, select SSID to enter
the SSID.
j
For the Advanced connection mode, assign the IP settings for
your network as necessary.
• If your network assigns addresses automatically, select IP Settings
to set the DHCP setting to On.
• If you must set addresses manually, select IP Settings to set the
DHCP setting to Off, and then enter the projector's IP Address,
Subnet Mask, and Gateway Address as necessary.
• If you want to connect the projector to the network using IPv6,
select IPv6 Settings.
s "Wireless LAN menu" p.159
k
To prevent the SSID or IP address from being displayed on the
LAN standby screen and Home screen, set the SSID Display
setting or the IP Address Display setting to Off.
l
If you have finished making settings, select Setup complete.
Follow the on-screen instructions to save the settings and close
the menu.
m
Press the [LAN] button on the remote control.
The wired network settings complete when you see the correct IP
address on the LAN standby screen.
When you have finished making wireless settings for your projector, you
need to select the wireless network on your computer. Then start the
network software to send images to your projector through a wireless
network.
Wireless Network Projection
132
To Next Page
Loading...
Need help?
General
