When an error has occurred in the projector, the error status is indicated by the indicator's color and combination of flashing or lit.
Refer to the following table to see what the indicators mean and how to remedy problems that they indicate.
Indicator Cause Remedy or Status
Power
supply
Status Laser Temp Filter
Off
Blue -
Flashing
Orange -
Flashing
Off Off
Internal Error Stop using the projector, remove the power plug from the electrical outlet, and contact your local dealer or
the nearest address provided in the Epson Projector Contact List.
s Epson Projector Contact List
Off
Blue -
Flashing
Off
Orange -
Flashing
Off
Fan Error
Sensor Error
Stop using the projector, remove the power plug from the electrical outlet, and contact your local dealer or
the nearest address provided in the Epson Projector Contact List.
s Epson Projector Contact List
Off
Blue -
Flashing
Off
Orange -
On
Off
High Temp Error
(Overheating)
The light source turns off automatically and projection stops. Wait for about five minutes. After about five
minutes the projector switches to standby mode, so check the following points.
• Check that the air filter, air exhaust vents, and air intake vents are clear, and that the projector is not
positioned against a wall.
• Check that the temperature near the air intake vents is not too high.
• If the air filter are clogged, remove the power cord from the electrical outlet, and then clean or replace
them.
s
"Cleaning the Air Filter" p.209
s "Replacing the Air Filter" p.212
If the error continues after checking the points above, stop using the projector, remove the power plug
from the electrical outlet, and contact your local dealer or the nearest address provided in the Epson
Projector Contact List.
s Epson Projector Contact List
When using at an altitude of 1500 m or more, set High Altitude Mode to On.
s Extended - Operation - High Altitude Mode p.151
Reading the Indicators
181
To Next Page
Loading...
Need help?
General
