124
How to Adjust the Print Start Position (Vertical Direction)
Adjust the print start position in the vertical direction to match the media form used.
When the print start position is adjusted, the cut position is also adjusted at the same time.
Media Form Description
Die-cut label (Gap)
• When the adjustment value is +, the print start position and cut
position move away from the reference position (top of label).
• When the adjustment value is –, the print start position and cut
position move closer to the reference position (top of label).
Die-cut label
(BlackMark)
• When the adjustment value is +, the print start position and cut
position move away from the reference position (black mark position).
• When the adjustment value is –, the print start position and cut
position move closer to the reference position (black mark position).
Printable area
Label
Reference position
(top of label)
Cut position
Paper feed
direction
Backing paper
Label
Print start position
Printable area
Label
Reference position
(black mark position)
Cut position
Paper feed
direction
Backing paper
Label
Print start position
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
