56
Loading and Replacing Fanfold Paper
This section describes how to load and replace fanfold paper. As shown below, the procedure differs
depending on the size and form (roll or fanfold) of the paper before and after the replacement.
Replacement Procedure List
c IMPORTANT
When replacing paper with a different shape, form, or type of paper, change the
media settings of the printer driver before loading the paper. (U "How to Use the
Pr
inter Driver" on page 73)
When loading fanfold paper for the first time or when changing from roll paper to fanfold paper
When changing to fanfold paper of a different width
When replacing with new fanfold paper after fanfold paper is used up
Turn the printer on (U page 57)
Star
t PrinterSetting and set the media source (U page 57)
Open the r
oll paper cover (U page 58)
Attach
the paper feed guide (U page 58)
Adj
ust the platen shutters to match the paper width (U page 59)
Release the
lock of the paper ejection guides (U page 59)
Ad
just the paper ejection guides to match the paper width (U page 60)
Lo
ck the paper ejection guides (U page 60)
Close the r
oll paper cover (U page 61)
Open the fanf
old paper cover (U page 61)
Release the
lock of the fanfold paper guides (U page 62)
Ad
just the fanfold paper guides to match the paper width (U page 62)
Loc
k the fanfold paper guides (U page 63)
In
sert the leading edge of the paper (U page 63)
Close the fanf
old paper cover (U page 64)
Ad
just the position of the fanfold paper (U page 64)
Check the LCD (U page 65)
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
Need help?
General
