46
Loading and Replacing Roll Paper
This section describes how to load and replace roll paper. As shown below, the procedure differs depending
on the size and form (roll or fanfold) of the paper before and after the replacement.
Replacement Procedure List
c IMPORTANT
When replacing paper with a different shape, form, or type of paper, change the
media settings of the printer driver before loading the paper. (U "How to Use the
Pr
inter Driver" on page 73)
When loading roll paper for the first time or when replacing with roll paper of a different width
When changing from fanfold paper to roll paper
When replacing with new roll paper after roll paper is used up
Turn the printer on (U page 47)
Star
t PrinterSetting and set the media source (U page 47)
Open the r
oll paper cover (U page 48)
Remov
e the paper feed guide (U page 48)
Release the l
ock of the roll paper guides (U page 49)
Ad
just the roll paper guides to match the paper width (U page 49)
Lo
ad the roll paper (U page 50)
Lo
ck the roll paper guides (U page 50)
Adj
ust the platen shutters to match the paper width (U page 51)
Release the
lock of the paper ejection guides (U page 52)
Pu
ll out the leading edge of the roll paper (U page 53)
Ad
just the paper ejection guides to match the paper width (U page 53)
Lo
ck the paper ejection guides (U page 54)
Close the r
oll paper cover (U page 54)
Check the LCD (U page 55)
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
Need help?
General
