Test Setup - Test Configurator, Timer, and System
132 88000 Series
Modify Structure Button
PHY Type allows selecting the transceiver PHY type:
For 100GE (4 Lanes) CFP4/QSFP: LR4/ER4 (default), SR4, CWDM4,
CLR4, AOC, or Other. The PHY type when set to any except LR4/ER4,
allows enabling RS-FEC (see page 223); ensure both ends of the circuit
have the FEC enabled.
For 400GE (8 Lanes) QSFP-DD: Optical (default) and DAC.
Primary Port / Secondary Port, available with Through Mode test
application, allows selecting the module’s ports that are respectively
used as primary and secondary ports. The configuration of the network
configuration parameters will be available on the Primary Port only.
Port1 - QSFP28 (selected by default), Port2 - QSFP28, Port3 - QSFP28,
and Port4 - QSFP28 check boxes, available with FlexE BERT, allows
selection of the Power Blazer’s ports used for FlexE PHYs.
To Next Page
Loading...
