Programming manual
CNC 8070
CYCLE EDITOR
Slot milling
12.
(SOFT V02.0X)
317
Finishing parameters:
The finishing operation is carried out in two stages.
First, it machines the bottom of the slot and then the side walls, with
tangential entry and exit.
The finishing operation defining parameters are:
Spindle turning direction (icon).
Clockwise with icon
(a)
.
Counterclockwise with icon
(b)
.
Machining direction (icon).
Clockwise with icon
(c)
.
Counterclockwise with icon
(d)
.
δ Finishing pass on the side walls.
δz Finishing pass at the bottom.
∆ Milling pass or width at the bottom of the slot.
The cycle recalculates the pass so that all the passes are
identical, with the same value as or smaller than the one
programmed.
If programmed with a 0 value, it assumes a value of 3/4 of the
diameter of the selected tool.
N Number of penetration passes (steps) for the side finishing. If
the resulting step is greater than the cutting length assigned
to the table in the tool table, the step will be limited to that value.
F Surface and side milling feedrate.
S Spindle speed.
T Finishing tool.
If programmed T=0, there is no finishing.
D Tool offset.
(b)(a)
(d)(c)
To Next Page
Loading...
