RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.3)
v
Using the Clear Changes button _____________________________________________________ 5-25
Using the TCP/IP page ______________________________________________________________ 5-26
Using the TCP/IP Status Web Page __________________________________________________ 5-27
Using the Printer page_______________________________________________________________ 5-28
Using the System Log page___________________________________________________________ 5-30
Changing the Log Name___________________________________________________________ 5-31
Selecting the Log Type____________________________________________________________ 5-33
Setting up Email Event logging _____________________________________________________ 5-35
Specifying UDP Event logging _____________________________________________________ 5-36
Specifying TCP Event logging ______________________________________________________ 5-38
Using the Administration pages _______________________________________________________ 5-40
Using the System Information page __________________________________________________ 5-40
Changing the Root Password _______________________________________________________ 5-42
Upgrading the Print Server_________________________________________________________ 5-44
Using the Reboot pages______________________________________________________________ 5-46
Rebooting the Ethernet Server ______________________________________________________ 5-46
Resetting to Default Settings _______________________________________________________ 5-48
Using the Help page ________________________________________________________________ 5-49
Additional Procedures ________________________________________________________5-50
Reviewing LED and Dipswitch Tables __________________________________________________ 5-50
Reviewing the LED Table _________________________________________________________ 5-50
Reviewing the Dip Switches________________________________________________________ 5-51
Restoring the Factory Settings for Ethernet ______________________________________________ 5-52
Restoring the Default Settings ______________________________________________________ 5-52
Accessing the IP address of your Printer_________________________________________________ 5-53
Accessing the HDP600 IP address ___________________________________________________ 5-53
Upgrading the Main Firmware with the Fargo Diagnostics Utility_____________________________ 5-54
Ethernet Printer Troubleshooting Procedures_____________________________________5-56
Troubleshooting procedures ________________________________________________________ 5-56
Verifying the Printer Connection ____________________________________________________ 5-57
Verifying the Printer IP address _____________________________________________________ 5-57
Verifying that your PC can access the Printer using the ping command ______________________ 5-58
Printing a test page _______________________________________________________________ 5-59
Reviewing Frequently-asked Questions __________________________________________5-60
Glossary of Terms ____________________________________________________________5-66
Section 6: Card Lamination Module __________________________________________6-1
Table of Contents ___________________________________________________________________ 6-1
Reviewing the Card Lamination Module _________________________________________________ 6-2
Safety Messages (review carefully)______________________________________________________ 6-3
Opening the Card Lamination Module_________________________________________________ 6-4
Adjusting the Card Lamination Module __________________________________________________ 6-6
Adjusting the Card Flattener_________________________________________________________ 6-6
Section 7: Printer Adjustments_______________________________________________7-1
Table of Contents ___________________________________________________________________ 7-1
Safety Messages (review carefully)______________________________________________________ 7-3
Adjusting the Card Size_______________________________________________________________ 7-4
Adjusting the Card Thickness Adjustment Lever_________________________________________ 7-4
Printing on Alternate Card stocks _______________________________________________________ 7-5
Selecting the Right Cards and optimize the HDP Print Process______________________________ 7-5
Selecting the Appropriate HDP Printer Driver settings ____________________________________ 7-6
Conducting the Tape adhesion Test ___________________________________________________ 7-7
Printer Driver Options_______________________________________________________________ 7-10
To Next Page
Loading...
