User Manual LTU Orion 3
119
BLOCK: port will be blocked upon receiving of non-listed packet
and SNMP Trap will be generated
List of allowed MAC addresses per interface
The <MACLIST SHOW [N/R/S/B]> command displays, depending on the parameter, one of four
configurations: New, Running, Startup, or Backup.
4.6.5.74 <MACLIST [IF] ADD [MAC]> Command
The <MACLIST [IF] ADD [MAC]> command adds [MAC] address to the White List of the specified
[IF] interface:
CX_05_NET>MACLIST 1 ADD 00-90-F5-3E-7F-AC
--------------------------------------------------------------------------------
New MAC Filter Configuration
--------------------------------------------------------------------------------
Port LAN1 LAN2 LAN3 LAN4 LAN5
Mode ON/FILTER ON/INDICATE ON/BLOCK ON/BLOCK OFF/FILTER
White list
1 0090f5-3e7a0b 0090f5-bb7a0b 0090f5-bb7a0b 0090f5-bb7a0b ---
2 0090f5-bb7a0b 0090cc-3e7a0b 0090cc-3e7a0b 0090cc-3e7a0b ---
3 0090cc-3e7a0b --- --- --- ---
4 0090f5-3e7fac --- --- --- ---
5 --- --- --- --- ---
6 --- --- --- --- ---
7 --- --- --- --- ---
8 --- --- --- --- ---
9 --- --- --- --- ---
10 --- --- --- --- ---
--------------------------------------------------------------------------------
It is allowed to use interface number or interface name, for example LAN1 as [IF] parameter.
System accepts ":" or "-" symbols as MAC address separator. It is possible to enter MAC address
without separator at all.
4.6.5.75 <MACLIST [IF] DEL [MAC/N]> Command
The < MACLIST [IF] DEL [MAC/N]> command deletes [MAC] address or entry number [N] from
the White List of [IF] interface:
CX_05_NET>MACLIST LAN1 DEL 5
--------------------------------------------------------------------------------
New MAC Filter Configuration
--------------------------------------------------------------------------------
Port LAN1 LAN2 LAN3 LAN4 LAN5
Mode ON/FILTER ON/INDICATE ON/BLOCK ON/BLOCK OFF/FILTER
White list
1 0090f5-3e7a0b 0090f5-bb7a0b 0090f5-bb7a0b 0090f5-bb7a0b ---
2 0090f5-bb7a0b 0090cc-3e7a0b 0090cc-3e7a0b 0090cc-3e7a0b ---
3 0090cc-3e7a0b --- --- --- ---
4 0090f5-3e7fac --- --- --- ---
5 --- --- --- --- ---
6 --- --- --- --- ---
7 --- --- --- --- ---
8 --- --- --- --- ---
9 --- --- --- --- ---
10 --- --- --- --- ---
--------------------------------------------------------------------------------
It is allowed to use interface number or interface name, for example LAN1 as [IF] parameter.
System accepts ":" or "-" symbols as MAC address separator. It is possible to enter MAC address
without separator at all.
To Next Page
Loading...
