E1CLOCK RX: E1 input clock
E1CLOCK EXT: External input clock.
E1CLOCK INT: Internal input clock.
4.6.5.26 <E1MODE [HDB3/AMI] [N]>, <E1MODE [SHORT/LONG] [N]> Commands
This command sets the E1 line coding to AMI or HDB3. And additionally it sets with short/long the
receiver sensitivity. Long means high receiver sensitivity required by long haul. Short means lower
sensitivity and signals below -12.5dB are considered as loss of signal.
4.6.5.27
<POWER ON
/OFF [N
=1..
4]> Comm
a
nd
This command activates/deactivates the remote power source for the selected [N] SHDSL
channel.
4.6.5.28 <ID string> Command
This command is used to enter an identification number on the device (text containing no more
that 12 symbols). This ID will be displayed on top the main menu. If the parameter is not written,
the device ID will be empty.
4.6.5.29 <DEFAULT [0-4]> Command
The <DEFAULT N> command sets the default operation mode, where N is the mode number
(there are four default operation modes).
• The DEFAULT 0 command sets the following mode: SLAVE, PAM 32, BASERATE 89,
ANNEX B, transmission of the E1 stream and Ethernet over SHDSL.
• The DEFAULT 1 command sets the following mode: MASTER, PAM 32, BASERATE 89,
ANNEX B, transmission of the E1 stream and Ethernet over SHDSL.
• The DEFAULT 2 command sets the following mode: SLAVE, PAM 32, BASERATE AUTO,
ANNEX A/B, transmission of the E1 stream and Ethernet over SHDSL.
• The DEFAULT 3 command sets the following mode: MASTER, PAM 32, BASERATE 89,
ANNEX B, transmission of the 2xE1 stream and Ethernet over SHDSL.
4.6.5.30 <DEFAULT EVERYTHING> Command
This command sets default operation modes for line parameters (see the DEFAULT command)
and for network parameters (see the <NETDEFAULT> command). The result of this command is
similar to the result of two commands:
DEFAULT 0
NETDEFAULT
4.6.5.31 <DEFAULT DESC> Command
This command writes default Port Description (ifAlias)
To Next Page
Loading...
